PEI bed on Support

 
 
IMPORTANT : Never tight the 3 screws, just tight a bit. The PEI sheet must dilate during heating
IMPORTANT : Ne jamais bloquer les 3 vis, serrer très légèrement. Le PEI doit pouvoir se dilater lorsque le Lit Chauffe
 
Precautions for use of PEI bed :
- Clean traces of ABS with acetone and kitchen paper, always cold bed.
- Warning : Never clean the bed PEI with acetone when the bed is hot, this may damage the PEI material.
- Always wait the bed is cold before removing the part
- If the printed piece stick too much on bed and is difficult to remove :
  • Reduce the "Z max Length" value in EEPROM by 0.05mm or 0.10mm  or increase the  Z Offset parameter in Kisslicer to 0.05mm or 0.10mm (KISSlicer Tab "Printer")
  • Decrease the bed temperature by 5°C steps.
 
Précautions d'utilisation du lit en PEI :
- Nettoyer les traces d'ABS avec de l'acetone et du papier absorbant, toujours lit froid
- Attention : Ne jamais nettoyer le lit en PEI avec de l'acetone lorsque le lit est chaud, ceci peut endommager le PEI
- Toujours attendre que le lit soit froid avant de retirer la pièce
- Si la pièce imprimée colle trop au lit et est difficile à enlever :
  • Réduire la valeur Z Max length de l'EEPROM de 0.05 ou 0.10mm ou changer le paramètre Z Offset dans KISSlicer à 0.05 ou 0.10mm
  • Réduire la température du Lit par pas de 5°C